Do you have some questions about how to use HoldTight’s salt remover surface cleaner? Then look no further than HoldTight’s website which is full of useful information about how you can use their products to better your infrastructure needs. For example, are you curious about how to use their HoldTight 102? Then have no fear. It’s easy to sue, you just add it to the water blaster of your wet abrasive blast rig. This could be a UHP water blaster or it could be a pressure washer. You can check out their link to an application guide on the website. Here is a clip that was pulled from HoldTight’s website that will give you more of an idea about the kind of services and culture they offer to you and your industry:
“Achieve 100% Cleanliness in One Simple Step. It’s no secret that coatings last longer and perform better on a clean surface. Most cleaning methods, however, cause problems of their own. Dry blasting shatters the rust and coating on the surface and embeds abrasive contaminants to become stuck into the roughened surface. Wet abrasive blasting with untreated water causes flash rust. Other salt removers only remove a few salts, while replacing them with other salts and leaving behind an acidic, conductive residue. With HoldTight®, however, there are NO contaminants, NO flash rust, and NO residue or film.
“HoldTight® completely removes all salts and therefore all conductivity. It also removes abrasives and debris from the surface’s profile providing a better surface area to bond with coating. Since HoldTight® leaves a clean, rust-free surface for up to 72 hours, large areas of structures can be blasted and cleaned completely before coating application, instead of having to be coated immediately after blasting every day.
“HoldTight® can be worked into any blasting process to achieve a totally clean surface, with zero flash-rust and zero residue left behind. HoldTight® is a clear, simple additive with visible results, eliminating both natural and artificial contaminants. At sea or on land, HoldTight® is safe to use and compatible with a wide variety of surfaces, including steel, concrete, fiberglass, aluminum, composites, and more!”
Additionally, you might be curious how long it will take for the surface to remain rust free after the cleaning with their HoldTight industrial surface cleaner. The answer is easy, the surface with remain clean for 2 to 4 days depending on what is happening environmentally around your infrastructure. The things to keep in mind are precipitation, humidity, temperature and more. You can see the Product Data Sheet for more in-depth information on this matter.
If you are concerned about the use of HoldTight interfering with coating adhesion, have no fear because typically there isn’t an issue. You can look up their “compatability” memo on their website to see what kind of coating manufacturers are offering approval for the products used on their surfaces.
Give HoldTight a chance to show you their extreme power in rust prevention. Their products are easy to use and are entirely environmentally friendly as well as affordable.